Hello!
I decided to try on Mac OS via Thunderbolt FireWire 800 adapter cable A1463 / MD464ZM. The device was found, but not consistently behaved - periodically loses connection, then all was lost. I connect to Windows, where previously there was no problem with him, but this time the device was not found.
In the absence of an external power supply Konnekt 6 is powered by firewire, but the blue LED on the firewire connection is off.
When connecting a guitar input and output LEDs and level controls are working, sound is output to the headphones and monitors. Does it work only with analog paths or through the "ADC - processor (and thus the firmware?) - DAC"?
Electrical fault in the circuit or firewire interface flew all the same firmware?
Log on UART:
RedBoot(tm) bootstrap and debug environment [ROMRAM]
Non-certified release, version v2_0 - built 17:43:47, Aug 16 2007
Platform: TC DICE Basic (ARM7TDMI)
Copyright (C) 2000, 2001, 2002, Red Hat, Inc.
RAM: 0x00000000-0x00800000, 0x00016ed0-0x007ed000 available
FLASH: 0x04000000 - 0x04200000, 32 blocks of 0x00010000 bytes each.
== Executing boot script in 20.000 seconds - enter ^C to abort
RedBoot> fis load dice
RedBoot> go
**********************************************************
* TC Command Line Interface System *
* Copyright 2003-2008 by TC Electronic A/S *
**********************************************************
* TC Dice Foundation: DiceJr Appl *
* Appl Ver.: 2.02 RELEASE *
* - date Sep 25 2008 18:54:20 *
**********************************************************
* Svn Ver.: 2221 - rng 2221 *
* - date 2008/09/04 09:57:45 *
* svn://svn/DICEAPP/trunk/diceApp/projectEIO4 *
**********************************************************
* Target: DesktopKonnekt6 PT2 *
* TC Electronic DiceJr *
* S/N: 8734199 WWUID: 00016604 09001067 *
**********************************************************
>And it stops here. Kind of like the firmware does not start, even though version and its date of writing correctly and there are no reports of abuse checksum. It can disable debugging output through UART?
